Revision [16029]
This is an old revision of InstallationFullHDD made by darkcity on 2011-06-26 05:58:34.
How to Create a Full Installation on an Internal Hard Disk Drive (H.D.D.)
- Ensure that the target installation partition has >=350MB free space available
- Create a LiveDVD or InstallationFrugal LiveUSB
- Start the target computer with the LiveDVD/USB: if the computer does not start/boot from the LiveDVD it will be necessary to either access a boot menu or the B.I.O.S. so that the computer is instructed to boot with the optical drive or U.S.B. flash memory drive and not any other type of drive; restarting will be necessary in conjunction with using the correct key(s) (see Appendix below);
- Configure the keyboard, locale & timezone settings {one is offered to do this either during start-up or immediately after}
- Prepare the H.D.D. (optional) using Menu > System > GParted; after any modifications re-start the computer without saving any changes and with the LiveDVD/USB connected
- Install to H.D.D. using Menu > System > Puppy Universal Installer
- Remove the LiveDVD/USB and re-start the computer without saving
http://www.youtube.com/watch?v=ASZm1aHDh_k
http://www.mygnulinux.com/?p=385
http://www.arsgeek.com/2006/12/05/installing-puppy-linux-to-your-hard-drive/
http://www.ph-islands.net/pupinstall/winxp.php
Also see
InstallationFrugal How to Create a Frugal Installation on an Internal or External Hard Disk Drive (H.D.D.)Appendix - Setting the correct boot sequence
How to alter the boot sequence:Table of BIOS keys
